Huawei SmartAX MA5616 Configuration Manual page 431

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Prerequisite
The number of xDSL ports is under the control of licenses. Make sure that sufficient licenses
are already requested.
Procedure
Step 1 Create a VLAN.
Create smart VLAN 50.
huawei(config)#vlan 50 smart
Step 2 Configure upstream ports.
Add upstream ports 0/0/1 and 0/0/0 to VLAN 50. Two ports are added for the purpose of port
aggregation.
huawei(config)#port vlan 50 0/0 0
huawei(config)#port vlan 50 0/0 1
To aggregate the two upstream ports as one aggregation group, set the packet forwarding mode
of the aggregation group to egress-ingress, and set the aggregation group to work in the LACP
static mode, do as follows:
huawei(config)#link-aggregation 0/0 0 0/0 1 egress-ingress workmode lacp-static
The aggregated ports must meet the following requirements: The ports must work in the full-duplex mode; the
port rates must be the same and the rate of an electrical port must not be of the auto-negotiation type; the attributes
of the ports, such as the default VLAN ID (PVID) and VLAN, must be the same; one port can belong to only
one aggregation group; the port must not be a mirroring destination port; the port must not be in the auto-
negotiation mode; the start port ID must be smaller than the end port ID.
Step 3 In the case of the ADSL access mode, follow this procedure.
1.
2.
3.
Issue 04 (2011-10-30)
NOTE
Configure an ADSL2+ profile. For details, see
The ID of the ADSL2+ line profile is 3, the downstream rate is 2048 kbit/s, the channel
mode is the interleave mode, the maximum interleave delay is 10 ms, and the SNR margin
is 6 dB.
huawei(config)#adsl line-profile quickadd 3 snr 60 30 120 60 30 120
huawei(config)#adsl channel-profile quickadd 3 interleaved-delay 10 10 rate
1024
2048 3096 1024 2048
3096
huawei(config)#adsl line-template quickadd 3 line 3 channel1 3 60 70 channel2
3
Activate the ADSL port. The port is port 0/2/0, and ADSL line template 3 and the default
alarm template (alarm template 1) are bound to the port.
NOTE
By default, an ADSL port is in the activated state. Before binding a template to the port, you must deactivate
the port.
huawei(config)#interface adsl 0/2
huawei(config-if-adsl-0/2)#deactivate 0
huawei(config-if-adsl-0/2)#activate 0 template-index 3
huawei(config-if-adsl-0/2)#alarm-config 0 1
huawei(config-if-adsl-0/2)#quit
Run the display traffic table ip command to query the traffic profiles that exist in the
system.
huawei(config)#display traffic table ip from-index
0
{ <cr>|to-
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Configuration Example of Services on the MA5616
Through GE Upstream Transmission
3.7.1 Configuring the ADSL2+ Profile.
420