Huawei SmartAX MA5616 Configuration Manual page 69

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Prerequisites
Run the switch adsl mode to rfc4706 command to switch to the ADSL mode NGADSL.
Context
The MA5616 supports two ADSL modes, that is, ADSL mode and NGADSL mode. The two
modes can be switched by running a command.
In this document, the configuration specified is based on the NGADSL mode. By default, the
system supports the ADSL mode.
l
l
l
Figure 3-23
Figure 3-23 Flowchart for configuring an ADSL2+ template
Flowchart for configuring a
Procedure
l
Issue 04 (2011-10-30)
When activating an ADSL2+ port, you need to bind the ADSL2+ line template and alarm
template to the port.
An ADSL2+ line template should be formed by binding an ADSL2+ line profile with an
ADSL2+ channel profile.
An ADSL2+ line alarm template should be formed by binding an ADSL2+ line alarm
profile with an ADSL2+ channel alarm profile.
shows the flow for configuring an ADSL2+ template.
line template
Start
Configure an
ADSL2+ line profile
Configure an
ADSL2+ channel profile
Configure an
ADSL+ line template
End
Configure an ADSL2+ line template.
1. Run the adsl line-profile quickadd command to quickly add an ADSL2+ line profile,
or run the interactive adsl line-profile add command to add an ADSL2+ line profile.
Main parameters:
– transmode and Transmission mode (in interactive mode): Indicates the line
transmission mode. By default, the system supports all transmission modes. The
user can adopt the default value for auto-adaptation.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Flowchart for configuring an
alarm template
Start
Configure an
ADSL2+ line alarm profile
Configure an ADSL2+
channel alarm profile
Configure an
ADSL2+ alarm template
End
3 Basic Configuration
58