Huawei SmartAX MA5616 Configuration Manual page 520

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Issue 04 (2011-10-30)
NOTE
l The VLAN ID must be consistent with the CVLAN of the OLT.
l An MA5616 (ONU) provides two upstream ports 0/0/0 and 0/0/1 and supports self-adaptation
among three modes.
huawei(config)#vlan 1001-1024 smart
huawei(config)#port vlan 1001-1024 0/0 1
4. Configure a VDSL2 line profile.
– Run the display vdsl line-profile command to query the existing VDSL2 line
profiles in the current system. A profile can be directly used if it meets the
requirements.
– If no VDSL2 line profile in the system meets the requirements, you need to add a
VDSL2 line profile. Run the vdsl line-profile quickadd command to quickly add
a VDSL2 line profile.
The data in the VDSL2 line profile must be configured according to the actual line
conditions. In this example, quickly add VDSL2 line profile 4 by using default settings
for the parameters.
huawei(config)#vdsl line-profile quickadd 4
5. Configure the VDSL2 channel profile.
– Run the display vdsl channel-profile command to query the existing VDSL2
channel profiles in the current system. A profile can be directly used if it meets the
requirements.
– If no VDSL2 channel profile in the system meets the requirements, you need to
add a VDSL2 channel profile. Run the vdsl channel-profile quickadd command
to add a VDSL2 channel profile.
NOTE
The data in the VDSL2 channel profile must be configured according to the actual channel
conditions. In this example, the traffic profile is used to limit the subscriber access rate;
therefore, when the VDSL2 channel profile is configured, the line rate parameters do not need
to be configured.
Quickly add VDSL2 channel profile 4 and use default settings for the parameters.
huawei(config)#vdsl channel-profile quickadd 4
6. Configure the VDSL2 line template.
– Run the display vdsl line-template command to query the existing VDSL2 line
templates in the current system. A template can be directly used if it meets the
requirements.
– If no VDSL2 line template in the system meets the requirements, you need to add
a VDSL2 line template. Run the vdsl line-template quickadd command to add a
VDSL2 line template.
Bind the VDSL2 line profile configured in
configured in Step 5
upstream rate adaptation ratio to 100%.
huawei(config)#vdsl line-template quickadd 3 line 4 channel1 4 100 100
7. Activate VDSL2 port 0/1/0 and bind line template 3 to it.
NOTE
The other VDSL2 ports can be activated similarly. If you want to activate all the ports of a board,
use the command activate all.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Step 4
Set the downstream rate adaptation ratio to 100% and the
10 Configuration Examples of the FTTx
and the VDSL2 channel profile
509