Huawei SmartAX MA5616 Configuration Manual page 278

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Item
IUA link
Issue 04 (2011-10-30)
Software parameters of the
MG interface
Ringing mode of the MG
interface
Terminal ID (TID) format of
the MG interface
IUA link set
IUA link
NOTE
The local port
ID, local IP
address,
remote port
ID, and
remote IP
address of
different links
must not be
completely
same;
otherwise, the
service cannot
be
configured.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Remarks
Whether the MG interface
supports the functions such as
dual homing and emergency
standalone is determined by the
service requirements.
Which ringing mode is used by
the MG interface is determined
by the service requirements.
The TID format determines the
generation mode of various types
of user terminals on an MG
interface.
The IUA link can be configured
only after the IUA link set is
configured.
IUA link ID It indicates the link for
transmitting the signaling.
IUA link set ID -
Local port ID To activate the link normally, it
must be the same as the remote
port ID configured on the MGC.
Local IP It must be the same as the remote
address IP address of the link configured
on the MGC. In addition, the local
IP addresses of the links that are
in the same link set must be the
same. (The IP address must exist
in the media IP address pool.)
Remote port To activate the link normally, it
ID must be the same as the local port
ID configured on the MGC.
267