Huawei SmartAX MA5616 Configuration Manual page 262

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Context
l
l
l
l
l
Precaution
l
l
l
Procedure
Step 1 According to the Usage Guidelines of the ringmode add command, check whether the preset
ringing mode in the system meets the requirement.
l If the requirement is met, go to
l If the requirement is not met, go to
Step 2 In the global config mode, run the user defined-ring modify command to configure the user-
defined ringing mode.
Step 3 Run the display user defined-ring command to query the user-defined ringing.
Step 4 Run the interface sip command to enter the SIP mode.
Step 5 Run the ringmode add command to add the ringing mapping.
Run this command to configure the ringing mode for the users on the same SIP interface. The
key parameters are described as follows:
l cadencering: Indicates the cadence ringing mode. The range 128-143 of this parameter
l initialring: Indicates the initial ringing mode. The range 144-159 of this parameter
Step 6 Run the display ringmode command to query ringing mapping records.
----End
Issue 04 (2011-10-30)
If the preset ringing modes of the system can meet the user requirements, you can select
the required ringing mode and configure the corresponding ringing mapping.
If the preset ringing modes cannot meet the user requirements, you can use the user-defined
ringing mode and configure the corresponding ringing mapping.
You can configure the cadence duration for the user-defined ringing to form different
ringing modes.
The user-defined ringing modes are 0-15, which correspond to the cadence ringing modes
128-143 and initial ringing modes 144-159 defined by the user. For example, if the user-
defined cadence ringing mode is 128, user-defined ringing mode 0 is selected. If the user-
defined initial ringing mode is 144, user-defined ringing mode 0 is selected.
The system supports a maximum of 16 records of the ringing mode mapping.
The ringing mapping name must be unique on the same SIP interface.
An index can be used for adding only one ringing mode on the same SIP interface.
The 16 user-defined ringing modes can be modified but cannot be added.
NOTE
l To use the user-defined ringing mode, perform this step and you can define the 0-15 ringing types.
l After configuring the user-defined ringing mode, you need to reset the corresponding service board to
make the configuration take effect, so that the user of the service board can use the new ringing mode.
If the service board has been in service for a period, evaluate the impact on the online users before
resetting the service board, and then determine whether to perform this operation.
corresponds to user-defined ringing modes 0-15.
corresponds to user-defined ringing modes 0-15.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Step 4.
Step 2.
7 Configuring the Voice Service
251