Huawei SmartAX MA5616 Configuration Manual page 239

SmartAX MA5616 Multi-service Access Module
Configuration Guide
1. The peer parameter mgcpara that is on the MG and issued by the MGC must be the same as
2. User-defined ringing modes 0 to 15 correspond to cadence ringing modes 128 to 143
Step 5 Check whether the ringing mapping is the same as that in the data plan.
Run the display mg-ringmode attribute command to check whether the ringing mapping is the
same as that in the data plan.
----End
Example
Assume that the MG interface ID is 0, the peer parameter ID issued by the MGC is 0, the cadence
ringing is 1:4 (the value of the corresponding parameter cadence is 0), and the initial ringing is
1:2 (the value of the corresponding parameter initialring is 17). To configure the ringing mode
of MG interface 0, do as follows:
huawei(config)#interface h248 0
huawei(config-if-h248-0)#mg-ringmode add 0 0 17
huawei(config-if-h248-0)#display mg-ringmode attribute
{ <cr>|mgcpara<U><0,15> }:
Command:
-------------------------------------------------------
-------------------------------------------------------
-------------------------------------------------------
Assume that the MG interface ID is 0, the peer parameter ID issued by the MGC is 0, the break-
make ratio of user-defined ringing mode 0 is 0.4sec On, 0.2sec Off, 0.4sec On, 2.0sec Off, and
the initial ringing and the cadence ringing use user-defined ringing mode 0 (the values of the
corresponding parameters cadence and initialring are 128 and 144 respectively). To configure
the ringing mode of MG interface 0, do as follows:
huawei(config)#user defined-ring modify 0 para1 400 para2 200 para3 400 para4 2000
huawei(config)#display user defined-ring
--------------------------------------------------
RingType Para1 Para2 Para3 Para4 Para5 Para6
--------------------------------------------------
0
1
2
3
......
14
15
--------------------------------------------------
huawei(config)#interface h248 0
huawei(config-if-h248-0)#mg-ringmode add 1 128 144
huawei(config-if-h248-0)#display mg-ringmode attribute
{ <cr>|mgcpara<U><0,15> }:
Issue 04 (2011-10-30)
CAUTION
the parameter mgcpara on the MGC.
respectively, and correspond to initial ringing modes 144 to 159 respectively. For example,
if the cadence ringing mode is 128, user-defined ringing mode 0 is selected. If the initial
ringing mode is 144, user-defined ringing mode 0 is selected.
display mg-ringmode attribute
MGID PeerPara
0 0
400 200
0 0
0 0
0 0
0 0
0 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
CadenceRing InitialRing
0 17
400 2000 0
0 0 0
0 0 0
0 0 0
0 0 0
0 0 0
7 Configuring the Voice Service
0
0
0
0
0
0
228