Huawei SmartAX MA5616 Configuration Manual page 279

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Item
ISDN BRA user data
(The data must be
consistent with the
data on the MGC.)
Issue 04 (2011-10-30)
Slot that houses the DSLD
service board
User data
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Remarks
Remote IP It must be the same as the local IP
address address of the link configured on
the MGC. The SCTP protocol
supports the multi-homing
function. That is, one link can be
configured with the IP addresses
of multiple MGCs as the remote
IP addresses. When one MGC is
faulty, the link can be switched to
other MGCs automatically. This
ensures that the service is not
affected. The MA5616 supports
the configuration of the active
remote IP address and standby
remote IP address.
1-4
Termination If the TID format bound to the
ID BRA user does not support
terminal layering function, this
parameter needs to be configured,
and the configuration must be
consistent with the configuration
on the MGC.
User priority The user priority must be
specified according to the service
requirements. There are three
categories of user priorities,
which are as follows:
l cat1: government1 (category
1 government user)
l cat2: government2 (category
2 government user)
l cat3: normal (common user,
default)
The priorities of cat1, cat2, and
cat3 are in descending order.
Interface ID It indicates the interface for the
BRA user data to pass through the
MG and MGC. The configuration
of this parameter must be
consistent with the corresponding
configuration on the MGC.
268