Huawei SmartAX MA5616 Configuration Manual page 542

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Procedure
l
Issue 04 (2011-10-30)
Configure the OLT.
1. Create an SVLAN and add an upstream port to it.
Create smart VLAN 1000 and add upstream port 0/19/0 to it.
huawei(config)#vlan 1000 smart
huawei(config)#port vlan 1000 0/19 0
2. (Optional) Configure upstream link aggregation.
In this example, a single upstream port is used. In the case of multiple upstream ports,
upstream link aggregation can be configured to implement protection between ports
and load sharing. For details, see
3. Configure GPON ONU profiles.
GPON ONU profiles include the DBA profile, line profile,and alarm profile.
– DBA profile: A DBA profile describes the GPON traffic parameters. A T-CONT
is bound to a DBA profile for dynamic bandwidth allocation, improving the
upstream bandwidth usage rate.
– Line profile: A line profile describes the binding between the T-CONT and the
DBA profile, the QoS mode of the traffic stream, and the mapping between the
GEM port and the ONU-side service.
– Alarm profile: An alarm profile contains a series of alarm thresholds to measure
and monitor the performance of activated ONU lines. When a statistical value
reaches the threshold, the host is notified and an alarm is reported to the log host
and the NMS.
a. Configure a DBA profile.
You can run the display dba-profile command to query the DBA profiles
existing in the system. If the DBA profiles existing in the system do not meet the
requirements, you need to run the dba-profile add command to add a DBA
profile.
Configure the DBA profile name to IPTV, type to Type4, and upstream
bandwidth to 100 Mbit/s.
huawei(config)#dba-profile add profile-name IPTV type4 max 102400
b. Add an ONU line profile.
Add GPON ONU line profile 10 and bind T-CONT 3 to DBA profile named
IPTV. In this way, the T-CONT can flexibly provide DBA solutions based on
different configurations in the DBA profile.
NOTE
The ONU line profile to be created must not exist in the system. Please create proper ONU
line profile according to actual data plan. This topic considers creating the ONU line profile
10 for example.
huawei(config)#ont-lineprofile gpon profile-id 10
huawei(config-gpon-lineprofile-10)#tcont 3 dba-profile-name IPTV
Add GEM port 0 for carrying management traffic streams and GEM port 1 for
carrying traffic streams of the IPTV service. Bind GEM port 0 and GEM port 1
to T-CONT 3. Configure the QoS mode to priority-queue (default).
huawei(config-gpon-lineprofile-10)#gem add 0 eth tcont 3 cascade on
huawei(config-gpon-lineprofile-10)#gem add 1 eth tcont 3 cascade on
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
10.3 Configuring Upstream Link Aggregation.
531