Huawei SmartAX MA5616 Configuration Manual page 508

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Issue 04 (2011-10-30)
After an ONU is added, run the display ont info command to query the current status
of the ONU. Ensure that Control flag of the ONU is active, Run State is online, and
Config state is normal.
huawei(config-if-gpon-0/2)#display ont info 1 1
---------------------------------------------------------------------
F/S/P
0/2/1
ONT-ID
1
Control flag
activated.
Run state
online normally.
Config state
of the ONU is normal.
...//The rest of the response information is omitted.
If the ONU state fails, the ONU fails to be in the up state, or the ONU does not match,
refer to the following suggestions to rectify the fault.
– If Control flag is deactive, run the ont activate command in the GPON port mode
to activate the ONU.
– If the ONU fails to be in the up state, that is, Run state is offline, the physical line
may be broken or the optical transceiver may be damaged. You need to check both
the material and the line.
– If the ONU state fails, that is, Config state is failed, the ONU capability set
outmatches the actual ONU capabilities. In this case, run the display ont failed-
configuration command in the diagnosis mode to check the failed configuration
item and the failure cause. Then, rectify the fault according to actual conditions.
NOTE
If an ONT supports only four queues, the values of 4-7 of the priority-queue parameter in the
gem add command are invalid. After configuration recovers, Config state will be failed.
6. Configure the management channel from the OLT to the ONU.
a. Configure the inband management VLAN and IP address of the OLT.
To telnet to the ONU from the OLT and then configure the ONU, you need to
configure the inband management VLANs and IP addresses of the OLT and the
ONU on the OLT.
Create management VLAN 8, and configure the inband management IP address
to 192.168.50.1/24.
huawei(config)#vlan 8 smart
huawei(config)#interface vlanif 8
huawei(config-if-vlanif8)#ip address 192.168.50.1 24
huawei(config-if-vlanif8)#quit
b. Configure the inband management VLAN and IP address of the ONU.
Configure the static IP address of the ONU 1 to 192.168.50.2/24, the static IP
address of the ONU 2 to 192.168.50.3/24 , the gateway to 192.168.50.254 and
the management VLAN ID to 8 (the same as that of the OLT) .
huawei(config-if-gpon-0/2)#ont ipconfig 1 1 static ip-address
192.168.50.2
mask 255.255.255.0 gateway 192.168.50.254 vlan 8
huawei(config-if-gpon-0/2)#ont ipconfig 1 2 static ip-address
192.168.50.3
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
:
:
: active //Indicates that the ONU is
: online //Indicates that the ONU already goes
: normal //Indicates that the configuration status
497