Huawei SmartAX MA5616 Configuration Manual page 533

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Procedure
l
Issue 04 (2011-10-30)
Configure the OLT.
1. Create an SVLAN and add an upstream port to it.
Create smart VLAN 200 and add upstream port 0/19/0 to it.
huawei(config)#vlan 200 smart
huawei(config)#port vlan 200 0/19 0
2. (Optional) Configure upstream link aggregation.
In this example, a single upstream port is used. In the case of multiple upstream ports,
upstream link aggregation can be configured to implement protection between ports
and load sharing. For details, see
3. Configure GPON ONU profiles.
GPON ONU profiles include the DBA profile, line profile,and alarm profile.
– DBA profile: A DBA profile describes the GPON traffic parameters. A T-CONT
is bound to a DBA profile for dynamic bandwidth allocation, improving the
upstream bandwidth usage rate.
– Line profile: A line profile describes the binding between the T-CONT and the
DBA profile, the QoS mode of the traffic stream, and the mapping between the
GEM port and the ONU-side service.
– Alarm profile: An alarm profile contains a series of alarm thresholds to measure
and monitor the performance of activated ONU lines. When a statistical value
reaches the threshold, the host is notified and an alarm is reported to the log host
and the NMS.
a. Configure a DBA profile.
You can run the display dba-profile command to query the DBA profiles
existing in the system. If the DBA profiles existing in the system do not meet the
requirements, you need to run the dba-profile add command to add a DBA
profile.
Configure the DBA profile name to VoIP, type to Type4, assure bandwidth to
15 Mbit/s and maximum bandwidth to 30 Mbit/s.
huawei(config)#dba-profile add profile-name VoIP type3 assure 15360
max 30720
b. Configure an ONU line profile.
Create GPON ONU line profile 10 and bind T-CONT 2 to DBA profile VoIP.
In this way, the T-CONT can provide flexible DBA solutions based on different
configurations in the DBA profile.
NOTE
The ID of the line profile to be created must not exist in the system. Please create proper line
profiles according to actual data plan. In this example, line profile 10 is used.
huawei(config)#ont-lineprofile gpon profile-id 10
huawei(config-gpon-lineprofile-10)#tcont 2 dba-profile-name VoIP
Add GEM port 0 for transmitting management traffic streams and GEM port 1
for transmitting VoIP service streams. Bind GEM port 0 and GEM port 1 to T-
CONT 2. Set the QoS mode to priority-queue (default).
huawei(config-gpon-lineprofile-10)#gem add 0 eth tcont 2
huawei(config-gpon-lineprofile-10)#gem add 1 eth tcont 2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
10.3 Configuring Upstream Link Aggregation.
522