Huawei SmartAX MA5616 Configuration Manual page 271

SmartAX MA5616 Multi-service Access Module
Configuration Guide
l
Precaution
l
l
Procedure
Step 1 In privilege mode, run the display protocol support command to query the current protocol
type used on the MA5616.
l When the H.248 protocol is used, go to
l When the SIP protocol is used, go to
Step 2 In privilege mode, run the display local-digitmap command to query the default local digitmap.
l If the default local digitmap can meet the requirements, the configuration is complete.
l If the default local digitmap cannot meet the requirements, perform one or more operations
Step 3 Run the local-digitmap modify command to change the name, type, or body of the local
digitmap.
Step 4 Run the local-digitmap append command to add a digitmap body in the local digitmap.
Step 5 According to the data plan, run the local-digitmap add command to add a local digitmap.
Step 6 Run the display local-digitmap command to check whether the local digitmap is the same as
the planned local digitmap.
----End
Example
Assume that the H.248 protocol is used on the MA5616. To add a local digitmap with the data
listed in
Table 7-17 Local digitmap existing in the system
Digitmap Name
huawei
huawei(config)#local-digitmap add huawei normal ([2-8]xxxxxxx|[2-8]xxSxxxxxxx|13
xxxxxxxxx|0xxxxxxxxx|9xxxx|1[0124-9]x|F|x.F|[0-9].S)
huawei(config)#display local-digitmap all
------------------------------------------
Name: huawei
Issue 04 (2011-10-30)
For the meaning of each character in the digitmap body, see the Context in
(Optional) Configuring the Digitmap of an MG
When the H.248 protocol is used, the type of the local digitmap can only be normal.
When the SIP protocol is used, the type of the local digitmap can be normal, emergency,
scc, direct-centrex, or second-centrex. For the meaning of the digitmap type, see the
Parameter Description in the local-digitmap add command.
in Step 3, Step 4, and Step 5
Table 7-17, do as follows:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Step 5.
Step 2.
to configure a proper local digitmap.
Digitmap Type
normal
7 Configuring the Voice Service
Interface.
Digitmap Body
([2-8]xxxxxxx|[2-8]
xxSxxxxxxx|13xxxxxxxxx|
0xxxxxxxxx|9xxxx|1
[0124-9]x|F|x.F|[0-9].S)
7.1.1.4
260