Huawei SmartAX MA5616 Configuration Manual page 254

Multi-service access module
Table of Contents

Advertisement

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Item
Issue 04 (2011-10-30)
Default IP address
of the MG
Attribute
SIP interface ID
parameter
s of the SIP
interface
NOTE
Signaling port ID
Parameter
of the SIP
s listed
interface
here are
mandator
IP address of the
y, which
means
primary IMS core
that the
network device to
SIP
which the SIP
interface
interface belongs
fails to be
started if
Port ID of the
these
primary IMS core
parameter
network device to
s are not
which the SIP
configure
d.
interface belongs
Transmission
mode of the SIP
interface
Home domain of
the SIP interface
Index of the
profile used by the
SIP interface
IP address
obtaining mode of
the proxy server
Ringing Mode of the SIP
Interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Remarks
It is the IP address of the next hop from
the MA5616 to the IMS core network
device.
CAUTION
If the media IP address and the signaling IP
address are different and the media and the
signaling are transmitted upstream through
different gateways, ensure that they
correspond to correct gateways. Otherwise,
normal calls may fail.
It is the SIP interface ID used for the
VoIP service to be configured. The
MA5616 supports only one virtual
access gateway (VAG).
The value range is 5000-5999. The
protocol specifies the port ID to be
5060.
When dual homing is not configured,
parameters of only the primary IMS
core network device are required. If
dual homing is configured, the IP
address and the port ID of the secondary
IMS core network device must be
configured.
The transmission mode is selected
according to the requirements on the
IMS core network device. Generally,
UDP is adopted.
It corresponds to parameter home-
domain in the MG interface attributes.
It corresponds to parameter profile-
index in the MG interface attributes.
l In IP mode, the IP address and the
port ID of the primary proxy server
must be configured.
l In DNS-A or DNS-SRV mode, the
domain of the primary proxy server
must be configured.
The ringing mode of the SIP interface
is determined by service requirements.
243

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents