Huawei SmartAX MA5616 Configuration Manual page 92

SmartAX MA5616 Multi-service Access Module
Configuration Guide
of PC1, the BRAS discovers that the user account does not match the physical port information
and thus rejects the dialup access request of PC2.
Default Configuration
Table 3-14
Table 3-14 Default settings related to PITP
Parameter
PITP function
PITP sub-option 90
User-side PPPoE packet carrying the
vendor tag information
Procedure
Step 1 Configure the relay agent information option (RAIO). Before using the PITP function, you must
configure RAIO.
l Run the raio-mode mode pitp-pmode command to configure the RAIO mode in the PITP
l Run the raio-mode mode pitp-vmode command to configure the RAIO mode in the PITP
The PITP P mode supports all the RAIO modes; the PITP V mode currently supports only the
common and userdefine modes. When the auto-sensing traffic stream is configured, fill in
8191.35 as the VPI/VCI of the tag, regardless of whether the traffic stream has learned the VPI/
VCI or not.
user-defined: indicates the user-defined mode. In this mode, you need to run the raio-format
command to configure the RAIO format. Select a corresponding keyword for configuring the
RAIO format according to the PITP mode.
l In the PITP P mode, run the raio-format pitp-pmode command to configure the RAIO
l In the PITP V mode, run the raio-format pitp-vmode command to configure the RAIO
In the case of the user-defined RAIO format, configure the circuit ID (CID) and the remote ID
(RID). If the access mode is not selected, the configured format applies to all access modes. If
the access mode is selected, the configured format applies to only this access mode. The CID
format and RID format in the PITP V mode are the same:
l CID: Identifies the attribute information about the device.
l RID: Identifies the access information about the user.
In other modes, the RID format is fixed and therefore it need not be configured manually.
Step 2 Configure the PITP function.
Issue 04 (2011-10-30)
lists the default settings related to PITP.
P mode.
V mode.
format.
format.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Default Setting
Global function: disabled
VLAN-level function: enabled
Disabled
Disabled
3 Basic Configuration
81