Huawei SmartAX MA5616 Configuration Manual page 209

SmartAX MA5616 Multi-service Access Module
Configuration Guide
----End
Example
To configure the multicast log to be reported to log server 10.10.10.10 (active multicast log
server) in CDR mode through TFTP transmission, do as follows:
huawei(config)#file-server auto-backup cdr primary 10.10.10.10 tftp
huawei(config)#btv
huawei(config-btv)#igmp cdr enable
Result
Query the configuration of the multicast log server for receiving the multicast log reported in
CDR mode.
huawei(config)#display file-server auto-backup cdr
------------------------------------------------------------------------------
Server type: Primary
Trans mode : TFTP
TFTP.
IP address : 10.10.10.10
10.10.10.10.
------------------------------------------------------------------------------
Current Server: Primary server
Query the status and other parameters of the multicast log report in CDR mode.
huawei(config)#display igmp config global
----------------------------------------------------------------------
Authorization
Robustness variable
General query interval(s)
V2 General query response time(0.1s)
V3 General query response time(0.1s)
Specific query interval(0.1s)
V2 Specific query response time(0.1s) : 8
V3 Specific query response time(0.1s) : 8
Specific query number
V2 router present timeout(s)
User action report switch
Preview switch
Recognition time(s)
The time of reset preview-count
Issue 04 (2011-10-30)
– After the multicast log report function in CDR mode is enabled, the MA5616
reports local multicast logs to the multicast log server in the form of a file.
– After the multicast log report function in CDR mode is disabled, the MA5616
reports each single log to the syslog server in the default syslog mode.
3. Configure the parameters of the multicast log report in CDR mode.
– In BTV mode, run the igmp cdr-interval command to configure the interval of
the multicast log report in CDR mode. By default, the interval is 600s.
– In BTV mode, run the igmp cdr-number command to configure the maximum
number of logs that can be reported in CDR mode each time. When the number of
multicast logs in the CDR file reaches the preset value, the MA5616 reports the
logs. By default, the maximum number is 200.
4. Check whether the configuration is correct.
– Run the display file-server command to query the configuration of the multicast
log server for receiving the multicast log reported in CDR mode.
– Run the display igmp config global command to query the status and other
parameters of the multicast log report in CDR mode.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 Configuring the Multicast Service (Multicast VLAN Mode)
//The transmission mode of the multicast log is
//The IP address of the multicast log server is
: enable
: 2
: 125
: 100
: 100
: 10
: 2
: 400
: disable
: enable
: 30
: 04:00:00
198