Table of Contents
Advertisement
FusionPower6000 3.0
User Manual (Not Against a Wall)
----End
5.9.6 Setting Management System Parameters
5.9.6.1 Setting NetEco Parameters
Context
Choose System Settings > Service Management and check that the status of
Network Service is Start.
Procedure
Step 1 Apply for a fixed IP address or management system domain name/DNS server
address from the network administrator of the equipment room.
Step 2 Set ECC800-Pro communications parameters.
●
Issue 03 (2023-02-08)
NO TE
– After the first login, change the preset password in time to ensure system access
security.
– A password that has been used for a long time is more likely to be stolen or cracked.
The risk increases over time. Change the password once every three months.
– It is recommended that you use different user accounts to log in to the ECC800-Pro
WebUI and app concurrently. Otherwise, either of them will be logged out.
(WAN port networking) On the ECC800-Pro WebUI, set the IP address, subnet
mask, and default gateway, and click Submit.
Table 5-5 IP parameters
Path
System Settings
> System
Parameters >
Monitor IP >
WAN_n
Copyright © Huawei Digital Power Technologies Co., Ltd.
Parameter
Default Value
IP address
– WAN_1:
– WAN_2:
Subnet mask
255.255.255.0
5 Power-On Commissioning
Setting
Set this
192.168.8.10
parameter based
on the IP address
assigned by the
192.168.0.10
network
administrator.
Set this
parameter based
on the subnet
mask assigned
by the network
administrator.
187
Advertisement
Table of Contents
