Huawei SmartAX MA5616 Configuration Manual page 39

SmartAX MA5616 Multi-service Access Module
Configuration Guide
1.
2.
3.
Step 4 Add a route.
l If the configuration environment is set up as shown in
l If the remote WAN management environment is set up as shown in
huawei(config-if-vlanif30)#quit
huawei(config)#ip route-static 10.10.21.0 24 10.10.20.3
Step 5 Start Telnet.
Choose Start > Run on the maintenance terminal. In the Open address bar, enter telnet
10.10.20.2 (10.10.20.2 is the IP address of the VLAN L3 interface of the MA5616), as shown
in Figure 3-19
is displayed.
Figure 3-19 Starting Telnet
Step 6 Log in to the MA5616.
On the telnet interface, enter the user name and the password. By default, the super user name
is root and the password is mduadmin. When the login is successful, the system displays the
following information:
>>User name:root
>>User password:
Huawei Integrated Access Software (MA5616).
Copyright(C) Huawei Technologies Co., Ltd. 2002-2010. All rights reserved.
----End
Result
After logging in to the MA5616, you can manage the MA5616. For instructions on CLI, see CLI
Operation Characteristics.
Issue 04 (2011-10-30)
Run the vlan command to create a VLAN.
huawei(config)#vlan 30 smart
Run the port vlan command to add an upstream port to the VLAN.
huawei(config)#port vlan 30 0/0 0
In the VLANIF mode, run the ip address command to configure the IP address and subnet
mask of the VLAN L3 interface.
huawei(config)#interface vlanif 30
huawei(config-if-vlanif30)#ip address 10.10.20.2 255.255.255.0
route-static command to add a route to the next hop.
(considering the Windows OS as an example). Click OK, and the telnet interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic Configuration
Figure 3-16, you need not add a route.
Figure 3-17, run the ip
28