Huawei SmartAX MA5616 Configuration Manual page 276

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Table 7-20 Data plan for configuring the H.248-based VoIP ISDN BRA service
Item
MG interface data
(The data must be
consistent with the
data on the MGC.)
Issue 04 (2011-10-30)
Parameters of
the media
stream and
signaling
stream
Attribute
parameters of
the MG
interface
NOTE
There are
many MG
interface
parameters.
Only
mandatory
parameters
are listed here.
If the
mandatory
parameters
are not
configured,
the MG
interface
cannot be
started.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Remarks
Upstream It is used as the upstream VLAN
VLAN for of the VoIP service to be
media and configured. Standard VLAN is
signaling recommended.
streams
Uplink port for It is used as the uplink port for the
media and VoIP service to be configured.
signaling
streams
Media IP These IP addresses must be
address and contained in the media and
signaling IP signaling IP address pools. The
address media and signaling IP address
pools consist of all the IP
addresses of the L3 interface of
the upstream VLAN for media
and signaling streams.
Default IP It is the next hop IP address from
address of the the MA5616 to the MGC.
MG
MG interface It is the ID of the MG interface
ID used by the VoIP service to be
configured. The MA5616
supports only one VAG.
Signaling port It is the transport layer protocol
ID of the MG port ID used for the signaling
interface exchange between the MA5616
(AG) and the MGC.
The default signaling port ID
defined in H.248 is 2944 (text)
and 2945 (binary).
IP address of When dual homing is not
the primary configured, you can configure the
MGC to which parameters of only the primary
the MG MGC. When dual homing is
interface configured, you also need to
belongs configure the IP address and port
ID of the secondary MGC.
Port ID of the
primary MGC
to which the
MG interface
belongs
265