Huawei SmartAX MA5616 Configuration Manual page 43

SmartAX MA5616 Multi-service Access Module
Configuration Guide
l
Issue 04 (2011-10-30)
2. Enable the function of sending traps.
Run the snmp-agent trap enable command on the device for sending traps to the
NMS.
huawei(config)#snmp-agent trap enable standard
3. Configure the IP address of the target host of the traps.
Run the snmp-agent target-host command to configure the IP address of the target
host of the traps.
The host name is huawei, the IP address of the host is 10.10.1.10/24 (that is, the IP
address of the U2000), the name of the target host is ABC, the SNMP version is V1,
and the security name is private (that is, the SNMP community name).
huawei(config)#snmp-agent target-host trap-hostname huawei address
10.10.1.10 trap-paramsname ABC
huawei(config)#snmp-agent target-host trap-paramsname ABC v1 securityname
private
4. Configure the source IP address of the traps.
Run the snmp-agent trap source command to configure the source IP address of the
traps.
– In inband networking mode, the IP address of the upstream port is used as the
source IP address of the traps.
– In outband networking mode, the IP address of the maintenance network port is
used as the source IP address of the traps.
NOTE
This document considers the outband networking mode as an example.
huawei(config)#snmp-agent trap source meth 0
5. Save the data.
Run the save command to save the data.
huawei(config)#save
Configuration procedure on the NMS
NOTE
In inband networking mode, you only need to perform the configuration on the MA5616. This step
can be omitted because the MA5616 can be automatically discovered through the OLT.
In outband networking mode, you need to follow this step to perform the configuration on the NMS.
1. Add a route from the NMS to the device.
Configure the IP address of the gateway from the NMS server to network segment
10.50.1.0/24 to 10.10.1.1.
– In the Solaris operating system (OS), do as follows:
Run the route add 10.50.1.0 10.10.1.1 command to add a route.
Run the netstat -r command to query the information about the current routing
table.
– In the Windows OS, do as follows:
Run the route add 10.50.1.0 mask 255.255.255.0 10.10.1.1 command to add a
route.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic Configuration
32