Huawei SmartAX MA5616 Configuration Manual page 538

SmartAX MA5616 Multi-service Access Module
Configuration Guide
l
Issue 04 (2011-10-30)
huawei(config)#queue-scheduler wrr 10 10 20 20 40 0 0 0
Configure the mapping between the queues and 802.1p priorities. Priorities 0-7 map
queues 0-7 respectively.
huawei(config)#cos-queue-map cos0 0 cos1 1 cos2 2 cos3 3 cos4 4 cos5 5 cos6
6 cos7 7
11. Save the data.
huawei(config)#save
Configure the ONU.
NOTE
The configuration on ONU 1 and ONU 2 is the same. Take configuration on ONU 1 for example.
1. Log in to the ONU to perform the configuration.
On the OLT, use the management IP address of the ONU to log in to the ONU through
Telnet. User name: root (default). Password: mduadmin (default).
2. Configure the upstream port of the media stream and the signaling stream.
Create VLAN 200 and add upstream port 0/0/1 (0/9/0 for MA5603T) to the VLAN.
Configure the IP address of the VLAN Layer 3 interface to 17.10.10.10 and subnet
mask to 255.255.0.0.
NOTE
l The VLAN ID must be consistent with the CVLAN of the OLT.
l The VLAN ID of the default upstream Ethernet port is 1. Use the default VLAN if no
specific VLAN is required for the upstream transmission.
l If you need to use another VLAN to transmit packets in the upstream direction, run the
port vlan command to add the specified upstream port to the VLAN.
huawei(config)#vlan 200 smart
huawei(config)#port vlan 200 0/0 1
huawei(config)#port vlan 200 0/9 0
huawei(config)#interface vlanif 200
huawei(config-if-vlanif200)#ip address 17.10.10.10 24
huawei(config-if-vlanif200)#quit
3. Configure the media and signaling IP address pools.
Configure both the media IP address, the signaling IP address to 17.10.10.10 and the
media gateway address to 17.10.10.1.
huawei(config)#voip
huawei(config-voip)#ip address media 17.10.10.10 17.10.10.1
huawei(config-voip)#ip address signaling 17.10.10.10
huawei(config-voip)#quit
NOTE
l You can configure the attributes of the SIP interface only when the media IP address and
the signaling IP address exist in the media and signaling IP address pools.
l The media IP address and the signaling IP address can be different. You can plan the IP
addresses according to the actual network.
4. Configure the static route.
Because the IP address of the VLAN interface and the IP address of the IMS are in
different network segments, you should configure a route for the network segment
from gateway 17.10.10.1 to 200.200.200.0.
huawei(config)#ip route-static 200.200.200.0 24 17.10.10.1
5. Add an SIP interface.
Add SIP interface 0.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
//for MA5616
//for MA5603T
527