Huawei SmartAX MA5616 Configuration Manual page 529

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Issue 04 (2011-10-30)
NOTE
l The VLAN ID must be consistent with the CVLAN of the OLT.
l The VLAN ID of the default upstream Ethernet port is 1. Use the default VLAN if no
specific VLAN is required for the upstream transmission.
l If you need to use another VLAN to transmit packets in the upstream direction, run the
port vlan command to add the specified upstream port to the VLAN.
huawei(config)#vlan 200 smart
huawei(config)#port vlan 200 0/0 1
huawei(config)#port vlan 200 0/9 0
huawei(config)#interface vlanif 200
huawei(config-if-vlanif200)#ip address 17.10.10.10 24
huawei(config-if-vlanif200)#quit
3. Configure the media and signaling IP address pools.
Configure both the media IP address, the signaling IP address to 17.10.10.10 and the
media gateway address to 17.10.10.1.
huawei(config)#voip
huawei(config-voip)#ip address media 17.10.10.10 17.10.10.1
huawei(config-voip)#ip address signaling 17.10.10.10
huawei(config-voip)#quit
NOTE
l You can configure the attributes of the MG interface only when the media IP address and
the signaling IP address exist in the media and signaling IP address pools.
l The media IP address and the signaling IP address can be different. You can plan the IP
addresses according to the actual network.
4. Configure the static route.
Because the IP address of the VLAN interface and the IP address of the MGC are in
different network segments, you should configure a route for the network segment
from gateway 17.10.10.1 to 200.200.200.0.
huawei(config)#ip route-static 200.200.200.0 24 17.10.10.1
5. Add an MG interface.
Add MG interface 0.
huawei(config)#interface h248 0
Are you sure to add MG interface?(y/n)[n]:y
6. Configure the attributes of the MG interface.
– Signaling IP address: 17.10.10.10
– Coding mode: text
– Port number of the transport layer protocol: 2944
– Transfer mode: UDP
– IP address of the primary MGC: 200.200.200.200
– Port number of the transport layer protocol of the primary MGC: 2944
– Media IP address 1: 17.10.10.10
– The beginning negotiation version of H248 protocol: V2
NOTE
You must confirm these as follows before configuring the MG interface.
l The enrollment type of the MG interface: IP address or the domain name. It must be the same
strictly.
l The beginning negotiation version of H248 protocol: V1, V2 or V3 (default). Some softswitches
do not support the V3 version, resulting in the MG interface cannot enroll.
huawei(config-if-h248-0)#if-h248 attribute mgip 17.10.10.10 mgport
2944 code text transfer udp primary-mgc-ip1 200.200.200.200 primary-mgc-
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Configuration Examples of the FTTx
//for MA5616
//for MA5603T
518