Huawei SmartAX MA5616 Configuration Manual page 511

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Issue 04 (2011-10-30)
huawei(config)#adsl line-profile quickadd 4
5. Configure the ADSL2+ channel profile.
– Run the display adsl channel-profile command to query the existing ADSL2+
channel profiles in the current system. A profile can be directly used if it meets the
requirements.
– If no ADSL2+ channel profile in the system meets the requirements, you need to
add an ADSL2+ channel profile. Run the adsl channel-profile quickadd
command to add an ADSL2+ channel profile.
The data in the ADSL2+ channel profile must be configured according to the actual
channel conditions. In this example, the traffic profile is used to limit the user access
rate; therefore, when the ADSL2+ channel profile is configured, the line rate
parameters do not need to be configured.
Add ADSL2+ channel profile 4 and use default settings for the parameters.
huawei(config)#adsl channel-profile quickadd 4
6. Configure the ADSL2+ line template.
– Run the display adsl line-template command to query the existing ADSL2+ line
templates in the current system. A template can be directly used if it meets the
requirements.
– If no ADSL2+ line template in the system meets the requirements, you need to add
an ADSL2+ line template. Run the adsl line-template quickadd command to add
an ADSL2+ line template.
Bind the ADSL2+ line profile configured in
configured in Step 5
adaptation ratio to 100% and the upstream rate adaptation ratio to 100%.
huawei(config)#adsl line-template quickadd 3 line 4 channel1 4 100 100
7. Activate the ADSL2+ port and bind the line template to the ADSL2+ port.
Activate ADSL2+ port 0/1/1 and bind line template 3 to it.
NOTE
The other ADSL2+ ports can be activated similarly. If you want to activate all the ports of a board,
use the command activate all.
huawei(config)#interface adsl 0/1
huawei(config-if-adsl-0/1)#deactivate 1
huawei(config-if-adsl-0/1)#activate 1 template-index 3
8. (Optional) Bind the ADSL2+ alarm template to the port.
Bind default ADSL2+ alarm template 1 to the port. To meet actual requirements, you
can run the adsl alarm-template quickadd command to add an ADSL2+ alarm
template.
huawei(config-if-adsl-0/1)#alarm-config 1 1
9. Add a service port to the VLAN.
An MA5616 configured with an ADL board provides 32-channel ADSL2+ access
services. Use one of the service virtual ports as an example. The SVLAN is 1001, VPI
8, VCI 35, CVLAN untagged. The other service virtual ports can be added similarly
by replacing the right SVLAN and the ADSL2+ port ID.
huawei(config)#service-port 101 vlan 1001 adsl 0/1/1 vpi 8 vci 35 multi-
service user-vlan untagged rx-cttr 8 tx-cttr 8
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
to form ADSL2+ line template 3. Set the downstream rate
10 Configuration Examples of the FTTx
Step 4 and the ADSL2+ channel profile
500