Huawei SmartAX MA5616 Configuration Manual page 284

SmartAX MA5616 Multi-service Access Module
Configuration Guide
Parameter
transfer
start-negotiate-version
Step 3 Check whether the attribute of the MG interface is the same as that in the data plan.
Run the display if-h248 attribute command to check whether the attribute of the MG interface
is the same as that in the data plan.
----End
Example
Assume that the MG interface ID is 0, the H.248 protocol is used for interconnecting with the
MGC, the signaling IP address is 10.13.4.116, the transport layer protocol port ID is 2944, IP
address 1 of the primary MGC is 10.13.2.118, the transport layer protocol port ID of the primary
MGC is 2944, media IP address 1 is 10.71.46.69, media IP address 2 is 10.13.4.117, the H.248
protocol version is started to be negotiated based on the profile, the transaction reliability is
enabled. To add such an MG interface, do as follows:
huawei(config)#interface h248 0
Are you sure to add MG interface?(y/n)[n]:y
huawei(config-if-h248-0)#if-h248 attribute
primary-mgc-ip1 10.13.2.118 primary-mgc-port 2944 mg-media-ip1 10.71.46.69
mg-media-ip2 10.13.4.117 start-negotiate-version 0 retrans enable
huawei(config-if-h248-0)#display if-h248 attribute
-------------------------------------------------
MGID
MG Description
MG DomainName
Protocol
Start Negotiate Version
Profile Negotiation Parameter
Profile index
2833Encrypt
Codetype
Transfer Mode
HeartBeatGenTimer(s)
HeartBeatRetransTimes
HeartBeatRetransTimer(s)
MG signalling IP
MG signalling Port
MG media IP1
MG media IP2
MIDType
DeviceName
Issue 04 (2011-10-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Remarks
The transmission mode is selected according
to the requirements of the MGC. Generally,
UDP is used.
If the MGC connecting to the MG is a Huawei
device, the profile (parameter profile-index)
does not need to be set; if the MGC
connecting to the MG is a device of another
vendor, the profile (parameter profile-index)
must be set (the parameter value is prompted
on the CLI).
If the profile file in the system cannot meet
requirements, contact Huawei for technical
support.
mgip 10.13.4.116 mgport 2944 code text
0
-
-
H248
0
Disable
1:NoProfile("")
-
Text
-
60
3
60
10.13.4.116
2944
10.71.46.69
10.13.4.117
IP4_ADDR
-
273