Huawei SmartAX MA5616 Configuration Manual page 51

SmartAX MA5616 Multi-service Access Module
Configuration Guide
l
Issue 04 (2011-10-30)
Run the snmp-agent local-engineid command to configure the engine ID of the
SNMP environment to 0123456789.
NOTE
The engine ID of the SNMP environment must be the same as that configured on the
U2000.
huawei(config)#snmp-agent local-engineid 0123456789
Info: Modify the local-engineid will disable the configured SNMPv3
user, all
users must be reconfigured, proceed? (y/n)[n]:y
d. Set the SNMP version.
Run the snmp-agent sys-info command to set the required SNMP version.
huawei(config)#snmp-agent sys-info version v3
NOTE
The SNMP version on the device must be the same as that configured on the U2000.
2. Enable the function of sending traps.
Run the snmp-agent trap enable command on the device for sending traps to the
NMS.
huawei(config)#snmp-agent trap enable standard
3. Configure the IP address of the target host of the traps.
Run the snmp-agent target-host command to configure the IP address of the target
host of the traps.
The host name is huawei, the IP address of the host is 10.10.1.10/24 (that is, the IP
address of the U2000), the name of the target host is ABC, the SNMP version is V3,
the security name is user1 (when SNMP V3 is used, the security name is the USM
user name), and the traps are authenticated and encrypted.
huawei(config)#snmp-agent target-host trap-hostname huawei address
10.10.1.10 trap-paramsname ABC
huawei(config)#snmp-agent target-host trap-paramsname ABC v3 securityname
user1 privacy
4. Configure the source IP address of the traps.
Run the snmp-agent trap source command to configure the source IP address of the
traps.
– In inband networking mode, the IP address of the upstream port is used as the
source IP address of the traps.
– In outband networking mode, the IP address of the maintenance network port is
used as the source IP address of the traps.
NOTE
This document considers the outband networking mode as an example.
huawei(config)#snmp-agent trap source meth 0
5. Save the data.
Run the save command to save the data.
huawei(config)#save
Configuration procedure on the NMS
1. Add a route from the NMS to the device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Basic Configuration
40