Huawei SmartAX MA5616 Configuration Manual page 298

SmartAX MA5616 Multi-service Access Module
Configuration Guide
template that is bound to the type of users. Then, run the display tid-template command to
check whether the TID template supports the layering configuration. Hence, you can check
whether the user supports terminal layering.
Precaution
l
l
l
l
l
l
Procedure
Step 1 To query the template information.
Run the display tid-template command to query the information about the default TID template
of the system.
Step 2 Check whether the default TID template of the system meets the service requirements.
If the default TID template cannot meet the service requirements, run the tid-template add
command to add a TID template that meets the service requirements. If the default TID template
meets the service requirements, proceed to
Step 3 Enter the MG interface mode.
Run the interface h248 command to enter the MG interface mode.
Step 4 Configure the TID templates and the terminal prefix of various types of users on the current MG
(VAG).
l In H248 mode, run the tid-format rtp command to configure the TID template and terminal
l In H248 mode, run the tid-format pstn command to configure the TID template and terminal
l In H248 mode, run the tid-format pstn command to configure the TID template and the
l In H248 mode, run the tid-format pstn command to configure the TID template and terminal
Step 5 Check whether the TID template and the terminal prefix are the same as those in the data plan.
Run the display tid-format command to check whether the TID templates and the terminal
prefixes of various types of users on the current MG interface are the same as those in the data
plan.
----End
Issue 04 (2011-10-30)
There are 19 default TID templates (templates 0-18) in the system. The default TID
templates can be referenced, but cannot be added, modified, or deleted.
The configuration of terminal layering on the MG must be the same as that on the MGC.
If certain type of terminals exists on an interface and the interface is not disabled, the
terminal prefix of this type of terminals cannot be modified.
If a certain type of terminals exists on an interface, the TID format (including the terminal
prefix and the index of the TID template) of this type of terminals cannot be changed.
The terminal prefix must comply with the following syntax rules: The prefix must not
exceed 64 characters. Only letters, digits, "_", and "/" are the characters allowed for input.
The first character must be a letter, and the last character must not be a digit.
The length of the TID, which is generated by combining the TID template and the terminal
prefix that you configured, must not exceed 64 characters.
prefix of the RTP ephemeral termination.
prefix of the PSTN user.
terminal prefix of the ISDN BRA user.
prefix of the ISDN PRA user.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7 Configuring the Voice Service
Step 3.
287