Siemens SINUMERIK Commissioning Manual page 75

Configuring a logical drive comprises the following tasks:
● Path name with the following structure:
● and a softkey label (either a language-neutral or language-dependent softkey label by
Softkey "USB local"
As supplied: Connection 1 is pre-assigned as "USB local".
The ""USB local" softkey is always displayed in the Machine, Program, and Services
operating areas, even if it is not configured. This enables the front interface of the active
TCU or the configured interface of the PCU to be displayed.
Note
If an OEM softkey (horizontal softkey 7) is configured, a maximum of 7 network drives are
displayed in the program. The last entry is ignored.
Figure 2-9
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
"acttcu://<TCU connector>,<Partition>/<Path name>"
For the USB at a TCU name entry, connection field identifying the required connector,
and a partition number
means of alarm texts).
"Logical Drives" setting screen
Configuring the HMI system
2.3 Connecting network drives
69