Siemens SINUMERIK Commissioning Manual page 209

T1=TT1
T2=TT2
T3=TT3
A1=TA1
A2=TA2
A3=TA3
[SearchOfMagPlaces]
; Defines how the location search is to take place.
; Softkey text for 1st location search, locale-dependent
1_SoftkeyText=EL1
; Half location; left, right, top, bottom
1_ToolSizeLRTB=1,1,1,1
; Location type number for location search
1_PlaceTypeNo=1
; Softkey text for 2nd location search, locale-dependent
2_SoftkeyText=EL2
; Half location; left, right, top, bottom
2_ToolSizeLRTB=1,2,1,1
; Location type number for location search
2_PlaceTypeNo=1
; Softkey text for 3rd location search, locale-dependent
3_SoftkeyText=EL3
; Half location; left, right, top, bottom
3_ToolSizeLRTB=2,2,1,1
; Location type number for location search
3_PlaceTypeNo=1
; Softkey text for 3rd location search, locale-dependent
4_SoftkeyText=EL4
; Half location; left, right, top, bottom
4_ToolSizeLRTB=1,2,1,1
; Location type number for location search
4_PlaceTypeNo=2
; Tool OEM Data and Tool Application Data
; Help for UserDataParamIO lines:
; Format of data in magazine list and tool list.
; This format is used only to display data and, in some cases,
; to input data in the HMI, magazine list and tool list.
; In the NC the data format of the OEM data is "float".
; In parameter lines "named parameters" are used. Names are
; separated from the value by ":=". Parameters are separated by ","
; Blanks are allowed on the left and right of the parameter
; name, ":=", value and ",".
; Example for the syntax of lines in the OEM data format:
; "[ToolParams]"
; "UserDataParamIO5=
; Type:=Float, Res:=2,
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Tool management
6.2 Settings in the configuration file
203