Siemens SINUMERIK Commissioning Manual page 66

Configuring the HMI system
2.2 Configuring a channel menu
Differences between HMI sl and HMI Advanced
For HMI Advanced, a channel menu for the direct channel selection must be configured in
addition to the channel groups that are used for switching over the operating stations. This
configuration is not evaluated or might be missing for HMI sl.
The HMI Advanced then responds as follows:
● If the PCU 50.3 has a local display and if this local display has the operating rights,
● If an operating station with TCU for which no channel menu is configured in its file
● If an operating station with TCU for which one channel menu is configured in its file
HMI sl responds as follows:
● If an operating station for which no channel menu is configured has the operating rights,
● If an operating station for which one channel menu is configured in its file CONFIG.INI
See also
On displaying the channel menu in HMI Advanced: Configuration of a channel menu for
direct channel selection (1:1 configuration) (Page 53)
Configuration of the channel groups (NETNAMES.INI)
[own]
owner= HMI_1
[chan HMI_1]
selection
DEFAULT_logChanSet=channels
DEFAULT_logChan=K_1
ShowChanMenu=True
logChanSetList=channels
[channels]
logChanList=K_1, K_2, K_3, K_4
[K_1]
logNCName=NCU_1
ChanNum=1
60
channels are selected directly via the channel menu.
CONFIG.INI has the operating rights on PCU 50.3, channels are selected directly via the
channel menu.
CONFIG.INI has the operating rights on PCU 50.3, operating station switchover is
performed via the channel menu as defined in the configuration.
the channel switchover key is local, without a channel menu, i.e. switching to the next NC
channel.
has the operating rights, operating station switchover is performed via the channel menu
as defined in the configuration.
/* channel menu for direct channel
/* obligatory for HMI Advanced
/* of no significance for HMI sl
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)