Siemens SINUMERIK Commissioning Manual page 361

Accessing the dialog properties
Read and write access is provided to the following dialog properties within Methods (e.g.,
PRESS block)
● Hd = Header
● Hlp = Help display
● Var = System or user variable
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
Graphic position Position of the graphic in pixels (distance from left-
hand side, distance from right-hand side), in relation to
the upper left-hand corner of the dialog. The minimum
distance from the top is 18 pixels. The entries are
separated by a comma.
Attributes The specifications of the attributes are separated by a
comma.
Possible attributes are:
CMx Column mode: Column alignment
CM0 Default: The column distribution is carried out
separately for each line.
CM1 The column distribution of the line with the most
columns applies to all lines.
CB CHANGE block: Response when dialog is opened: cb
attributes specified for a variable in a variables
definition take priority over the default setting in the
dialog definition.
CB0 Default: All CHANGE blocks associated with the dialog
are processed when it is opened.
CB1 CHANGE blocks are then only processed if the
relevant value changes.
System The "System" property can be read during runtime:
0: HMI_Embedded
1: HMI_Advanced
2.2 Structure and elements of a dialog
Programming
2-11