Siemens SINUMERIK Commissioning Manual page 670

Commissioning a system
1.4 BIOS settings
Menu: Boot
System parameters
Boot priority order:
1: SATA0:
2: PCI BEV:
3:
4:
5:
6:
7:
8:
Excluded from boot order:
Menu: Version
System parameters
SIMATIC PC
BIOS version
BIOS number
MPI/DP firmware
CPU type
CPU ID
Code revision
Menu: Exit
Save Changes & Exit
Changing BIOS settings
Once additional components have been installed or attached, it may be the case that the
system has to be informed of this via the BIOS setup:
1. Ramp up the device.
2. When the prompt to activate the BIOS setup appears, press the <F2> key (corresponds
3. The BIOS setup menu appears. In the menu, use the cursor keys to navigate to the
4. Change the setting using the <+> key (press <SHIFT> and <X> at the same time) or the
5. Using the left-right cursor keys, you can reach other setup menus.
30
to horizontal softkey 2 on the OP).
desired selection box.
↔ key on in the numeric keypad.
Defaults
Fujitsu MHT2040BHTBD
VIA BootAgent
Defaults
SINUMERIK PCU50.3
V05.01.06
A5E00370214-ES005
V01
Celeron ® M processor 1.50GHz
06D8
0020
All changes are saved; a system restart is carried out with the
new parameters.
Commissioning Manual, 03/2009, 6FC5397-1DP10-4BA0
Custom entries
PCU-Basesoftware (IM8)