Siemens SINUMERIK Commissioning Manual page 176

Tool management
6.1 Setting tool management parameters on the HMI
Note
Up to 32 magazines (including buffer and loading magazine) are possible, therefore a
maximum of 30 real magazines.
Creating a new magazine
Follow the steps outlined below:
1. Press the "New" softkey. The magazine number is assigned by the system (in the order
2. Enter the magazine name with up to 32 characters in length. If it exists, the display text is
3. Select the magazine type:
4. Enter the number of magazine locations.
5. For box magazines, the "number of columns" must be entered too.
6. Accept the data with the "OK" softkey.
Note
If the message "invalid value in magazine" appears, the number of locations and/or
number of columns is incorrect. The "number of locations" value must be divisible by the
"number of columns".
Example: 20 locations cannot be divided into 3 columns, but 21 locations can be.
Deleting a magazine:
1. Select the magazine name.
2. Press the "Delete" softkey.
Note
A magazine can only be deleted if it is not assigned to any magazine configuration.
170
they were created).
immediately displayed from patm_xx.ini.
– Chain magazine
– Revolver
– Flat magazine
The magazine is deleted without a prompt.
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)