Siemens SINUMERIK Commissioning Manual page 132

Programming PLC Functions
4.6 Cross-channel status display
The following hierarchy applies (from highest to lowest priority):
1. Channel STOP (highest priority)
2. Spindle not enabled
3. Feed is not enabled
4. Channel active
5. Channel RESET (lowest priority)
Syntax:
ChanStatFeedStopSpindleStop = <Channel number>
Spindles = <Spindle number1>,...,<Spindle number n>
Channel number: Number of channel
Spindle number: Numbers of the "logical" spindles to be taken into
consideration
(programmed in the DIN code with S1 to Sn; if more than
one applicable entry, the higher number is displayed).
2 channel status
The channel status and spindle status are output as an icon at the display position (spindle
status can be separately output). The channel status icons can be superimposed with the
"Feed not enabled" icon.
The following hierarchy applies (from highest to lowest priority):
1. Channel STOP (highest priority)
2. Feed is not enabled
3. Channel active
4. Channel RESET (lowest priority)
Syntax:
ChanStatFeedStop = <Channel number>
Channel number: Number of channel
3 channel status
The channel status is output as an icon at the display position. Feed stop is also output in
the feed window in the Machine operating area, for example.
Syntax:
ChanStat = <Channel number>
Channel number: Number of channel
4 spindle status
The spindle status is output as an icon at the display position.
Syntax:
SpindStat = <Spindle number> , Chan <Channel number>
Spindle number: Number of (logical) spindle
Channel number: Number of channel optional
126
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)