Siemens SINUMERIK Commissioning Manual page 211

ApplDataParamName3 = TC_TPCS3
ApplDataParamName4 = TC_TPCS4
ApplDataParamName5 = TC_TPCS5
ApplDataParamName6 = TC_TPCS6
ApplDataParamName7 = TC_TPCS7
ApplDataParamName8 = TC_TPCS8
ApplDataParamName9 = TC_TPCS9
ApplDataParamName10 = TC_TPCS10
ApplDataParamIO1 = <EndOfList>
; ApplDataParamIO1 = Type:=Float, Res:=2
; ApplDataParamIO2 = Type:=Int
ApplDataParamSize = TC_TPCS_UNIT
ApplDataParamSize1 = <EndOfList>
; ApplDataParamSize1=TC_TPCS1_UNIT
; ...
; ApplDataParamSize10=TC_TPCS10_UNIT
; Example for the syntax of lines in the OEM data format:
; "[ToolEdgeParams]"
; "UserDataParamIO5=
; Type:=Float, Res:=2, Min:=-9999, Max:=9999 "Comment"
; "UserDataParamIO6=
; Type:=Int, Min:=-99, Max:=99"
; "UserDataParamIO7=
; Type:=Int, Min:=0, Max:=1"
; "5": Number of the OEM data
; "Type:=...": Defines the type of OEM data
; Default: "Floatn"
; "Float": Floating point as used in the NC. The number of
; decimal places depends on $MM_DISPLAY_RESOLUTION
; in mmc.ini and on the "res." in this parameter line.
; "Int": Integer (range: -999999999 to 999999999)
; "Res:=2": Resolution, accuracy: Number of
; decimal places if "Type:=Float" (floating-point number).
; Range from 0 to 6, default is $MM_DISPLAY_RESOLUTION.
; If "Res:=..." is greater than $MM_DISPLAY_RESOLUTION,
; only the places $MM_DISPLAY_RESOLUTION are displayed.
; "Min:=-9999": For the input: Minimum value
; "Max:=-9999": For the input: Maximum value:
; ";comment": Comment;
; Lines EdgeParamName...:
; Example: ; EdgeParamNameLLen1=TC_DP3
; Defines the text under which the cutting parameters and
; additive offset parameters in the tool detail screens
; are displayed.
; The sequence of the EdgeParamName... lines corresponds to
; the sequence in the screens.
; The sequence in the screens cannot be influenced by changing
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Tool management
6.2 Settings in the configuration file
205