Siemens SINUMERIK Commissioning Manual page 268

Tool management
6.7 Start-up of code carrier
Tool dialog data
The tool dialog data is defined as follows:
Dialog
variable
T1
T2
T3
T4
T5
T6
T7
T8
T9
T10
T11
T12
* The character string which is stored there is an HMI internal location type which is assigned
the value in $TC_TP7. This text is defined via the tool management start-up and stored in
the database.
Note
If chips are to be exchanged between several machines, the following rule applies if T12 is
used.
The location type names must be present in the same sequence on all these machines (with
the same location type numbers).
If changes are made to the conversion file, old code carriers can no longer be read!
Code carrier chip/SINTDC:
If the user has defined the dialog variable T11 in the conversion file wkonvert.txt for "Type of
tool search, $TC_TP10", the value from the NCK is written to the chip and written back to the
NCK at read in. If T11 is missing, the value is 0 in $TC_TP10 after the chip is read in.
262
Data type Designation
String Tool name, max. 32 characters
Integer Duplo number
Integer Number of cutting edges
Integer Tool size left in half locations
Integer Tool size right in half locations
Integer Tool size upper in half locations
Integer Tool size down in half locations
String Magazine location type
Integer Tool status
Integer Type of tool monitoring
Integer Type of tool search
Integer Magazine location type
Previously, only the name of the magazine
location type could be stored as a string via
dialog variable T8. The assignment
between location type number and location
type name and vice versa is made in the
tool management database.
Assignment $TC...
$TC_TP2
$TC_TP1
$P_TOOLND[tnr]
tnr=tool number
$TC_TP3
$TC_TP4
$TC_TP5
$TC_TP6
$TC_TP7*
$TC_TP8
$TC_TP9
$TC_TP10
$TC_TP7
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)