Siemens SINUMERIK Commissioning Manual page 572

Programming help systems
1.2 Quick "ASCII" help
Extract from TXT file "IFM_GR.COM":
...
a2//G00/Linear interpolation with rapid traverse (m) , quick help
a2//G01/Linear interpolation with feed (m)
...
a/20/"PGA.PDF",2,"="/=/Assignment operator with extended help
...
a/3/"PG.PDF",17,"ANG"/ANG/Contour angle (s) with extended cycle help
...
m/14/"PGZ.PDF",302,"CYCLE77"/CYCLE77/Circular spigot milling cycle
with extended cycle help
...
CONTEXT section
Increased context sensitivity of the help function can be selected in the [CONTEXT] section.
This setting is activated with "1" and deactivated with "0" (entered under "Settings").
If increased context sensitivity is activated and the cursor is positioned to the left of, next to
or on an instruction text, all instructions with the same initial letters are displayed when help
is called.
For example, if the programmer has selected instruction "G1", all instructions beginning with
"G1" (e.g., "G1", "G17", "G18", "G19") are displayed.
If increased context sensitivity has been deactivated with "0", then only the instruction
actually selected (if available) is displayed.
TEXTSEARCH section
The text search type can be specified in the [TEXTSEARCH] section. The following search
methods can be parameterized:
1 = Instruction texts only
2 = Descriptive texts only
3 = Instruction and descriptive texts
(entered under "Search").
10
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
Online Help (HE1)