Siemens SINUMERIK Commissioning Manual page 194

Tool management
6.2 Settings in the configuration file
SKTLLIST=7
; Displays the tool list
SKACLIST=7
; Displays the tool offset list
SKTOOLLOAD=5
; Loading tools
SKTOOLUNLOAD=5
; Unloading tools
SKTOOLMOVE=7
; Moving tools in the magazine
SKSETTINGS=4
; Softkey settings
SKFILFCT=4
; Softkey file functions
SKNXTCHAN=7
; Enable Next Channel softkey
SKMAGCONF=4
; Configuration of magazines
SKTOOLCAT=7
; Tool catalog
SKTOOLCAB=7
; Tool cabinet
SKSINCOMLD=7
; Load tool from SINCOM (if code carrier is installed)
SKCTORSINCOM=7
; Code carrier functions or tool loading from SINCOM
; (if code carrier is installed)
SKMGLREPR1=7
; Display 1_MagList
SKMGLREPR2=5
; Display 2_MagList
SKMGLREPR3=5
; Display 3_MagList
SKNCTOOLDATA=7
; Read tool data from NC or file management
; (if ACTIVATE_EDGE_MANAGEMENT_IN_LISTS=True)
SKNCTOOLED=7
; Cutting edge data
SKNCTOOLSUPV=7
; Supervision data
SKNCTOOLDL=7
; DL data
SKNCTOOLGRIND=7
; Grinding parameters
SKNCDETAILS=7
; Read tool data from NC
; (if ACTIVATE_EDGE_MANAGEMENT_IN_LISTS=True)
188
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)