Siemens SINUMERIK Commissioning Manual page 254

Tool management
6.4 Job processing of tools
A_TOOLMN: Magazine number
A_TOOLMLN: Magazine location number
P_TOOLND: Number of cutting edges
Tool cutting edge parameters
TC_DP1 to TC_DP24
Tool cutting edge monitoring parameters
TC_MOP1: Tool life warning limit
TC_MOP2: Tool life actual value
TC_MOP3: Pre-warning limit for count
TC_MOP4: Actual value for workpiece count
TC_MOP5: Prewarning limit for wear
TC_MOP6: Remaining wear
TC_MOP11: Setpoint for tool life
TC_MOP13: Setpoint for workpiece count
TC_MOP15: Setpoint for wear
Tool OEM data
TC_TPC1 to TC_TPC10
Tool OEM data must be activated on the NC and the numbers must be permissible on the
NC.
Tool cutting edge OEM data
TC_DTPC1 to TC_DTPC10
The tool cutting edge OEM data must be activated on the NC and the numbers must be
permissible on the NC.
Tool cutting edge monitoring OEM data:
TC_MOPC1 to TC_MOPC10
The tool cutting edge monitoring OEM data must be activated on the NC and the numbers
must be permissible on the NC.
Conditions
The following conditions can be used:
==
<
>
<=
>=
&&
248
Equal to
less than
Larger
Less than or equal to
Greater than or equal to
bit-wise AND between screen and data; only permissible for operands of type
WORD and DOUBLEWORD; the individual result bits are ORed.
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)