Siemens SINUMERIK Commissioning Manual page 503

State
50
60
Custom operating area
See chapter "Custom operating area".
4.5.2 Selectable states in HMI Embedded sl
Overview
There are the following configuration options for the state in HMI Embedded sl:
A configuration:
Configuration with 0:
4.5.3 Selectable states in ShopMill on NCU
Machine Manual
Legend:
*
Custom screen
State
19
2
30
5
7
31
32
33
8
34
9
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
Function
Optimization/test
HMI
Maintains current state.
The basic state of an operating area is activated.
If option available (display MD is set)
These designated functions can be configured with the "Expanding the
Operator Interface" system.
If this type of configuration is available, it is activated. Otherwise, the
standard ShopMill screen will appear.
Function
Main screen
T, S, M, etc.
Workpiece zero
Workpiece zero - set up edge
Workpiece zero – /user screen form
Workpiece zero – align edge/user screen form
Workpiece zero – spacing 2 edges/user screen form
Workpiece zero – rectangular edge
Workpiece zero – arbitrary edge/user screen form
Workpiece zero – rectangular pocket
Workpiece zero – 1 hole/user screen form
Configure hotkeys and PLC keys
4.5 List of selectable states
(V7.1 and later)
4-21