Siemens SINUMERIK Commissioning Manual page 484

Configure hotkeys and PLC keys
4.1 Introduction
● Selection of additional screens, depending on the current operating situation, in screens
Configuration
Configuration is carried out using the "Expand user interface" functions.
● The 6 OP hotkeys can be used to display any HMI operating area directly. This shortens
● The interface between the PLC and the HMI enables a PLC key to be transferred from
● As an option, the <Machine> and <MENU SELECT> keys can be configured in the same
4.1.1 OP hotkeys
Assignment (default setting)
The 6 OP hotkeys are laid out in 2 lines, each of which contains 3 keys:
Line 1 Label (no symbol)
OP-specific:
OP 10
OP 10C
OP 10S
Program
Offset
Line 2 Label (no symbol)
Program Manager
Alarm
Custom
Optional HK7 and HK8:
The <Machine> and <MENU SELECT> keys can be configured in the same way as HK1 to
HK6. This makes it possible to disable the default settings of these keys and to activate new,
user-defined functions.
Label (no symbol)
Machine
MENU SELECT
4-2
created using the "Expanding the Operator Interface" system.
the usual selection process via the main menu. This changes the default assignment of
the 6 hotkeys.
the PLC to the HMI. The operations initiated on the HMI system in this way can be
configured. Key numbers 50 to 254 are available for use by the PLC.
way as the 6 OP hotkeys and are assigned to HK7 and HK8.
Machine
Machine
Position
Configured as
HK1
HK1
HK1
HK2
HK3
Configured as
HK4
HK5
HK6
Configured as
HK7
HK8
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
Expanding the user interface