Siemens SINUMERIK Commissioning Manual page 513

Activation by keys
● Hotkey
● Horizontal softkey
Behavior during operating area change
When you change from the "Custom" operating area to another operating area and back
again, the window that was active when you closed the "Custom" operating area reappears
the next time you open it.
5.3 Defining the start dialog
5.3
Overview
The inputs in the CUSTOM.INI file are used to define the start dialog and those in the
RE_xx.INI file for the operating area name in HMI Advanced.
● Dialog header
● Picture in start dialog
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
The "Custom" hotkey on the OP 010 and OP 010C always activates this operating area
(default setting). Other additional configurations are possible.
Activation via the horizontal softkey 4 in the 1st expanded menu is the default setting.
The softkey assignment can be changed in HMI Advanced; in HMI Embedded sl, this is
done with the help of the Software Configuration Kit (SCK).
A text with the dialog header can be entered in this section [Header]. This can be in the
form of either text or an alarm text number, which will make the header language-
dependent:
[Header]
Text="XY special functions"
Text=$80XXX
Default setting: Text = "Custom"
In the [Picture] section, it is possible to enter a path to a picture that is displayed at the
start of the application:
[Picture]
Picture=\directory\bild.bmp
"Custom" operating area
5.3 Defining the start dialog
5-3