Siemens SINUMERIK Commissioning Manual page 253

SKBATLOAD=7; Softkey batch function "Load"
SKBATLIST=7; Softkeys for controlling the job processing
6.4.2 Settings that are valid for one filter at a time
Search criteria
The search criteria are set in "n_FindCondition" (with n=1 to 6) for each filter.
A maximum of 8 part conditions are permissible, separated by ",". They are ANDed. No data
may occur more than once in the part conditions.
Each part condition consists of three parts:
1. Datum for which the condition applies
2. Conditions
3. Comparison Value
Example:
1_FindCondition = TC_TP8 && 20, A_TOOLMN > 0
Filter 1 filters tools in the NC which fulfill the following condition:
( (prewarning bit set (bit5 of bit1 to 16 (2 to the power of (5-
1)=16))))
OR
(disabled bit set (bit3 (2 to the power of (3-1)=4)))
)
AND
( (magazine number > 0 means "loaded tool"))
Filter criterion
The following data in the NC can be a filter criterion:
Tool data
TC_TP1: Duplo number
TC_TP2: Tool identifier
TC_TP3: Tool size in half locations left
TC_TP4: Tool size in half locations right
TC_TP5: Tool size in half locations top
TC_TP6: Tool size in half locations bottom
TC_TP7: Tool location type
TC_TP8: Tool status
TC_TP9: Monitoring type
TC_TP10: Replacement tool search
TC_TP11: Tool information/replacement tool sequence
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Tool management
6.4 Job processing of tools
247