Siemens SINUMERIK Commissioning Manual page 291

69=CondWait.bmp
70=CondWait.bmp
71=CondWait.bmp
72=CondWait.bmp
73=CondWait.bmp
74=CondWait.bmp
75=CondWait.bmp
76=CondWait.bmp
77=CondWait.bmp
78=CondWait.bmp
79=CondWait.bmp
80=CondWait.bmp
81=CondWait.bmp
82=CondWait.bmp
[Pos1]
ChanStatFeedStopSpindleStop = 1 ;channel status, channel 1 is
displayed, superimposed
Spindles=1,2 ;from feed inhibit channel 1 and spindle inhibit
;for spindles 1 and 2
[Pos3]
SpindStat=1 ;spindle status of spindle 1
;ChanStatFeedStop = 3 ;channel status, channel 3 is displayed,
superimposed
;from feed inhibit, channel 3
[Pos5]
ChanStat = 2 ;channel status, channel 2 is displayed
;SpindStat= 3 ;spindle status, spindle 3 is displayed
[Pos9]
ChanStatFeedStopSpindleStop = 1 ;channel status, channel 1 is
displayed, superimposed
Spindles=1 ;from feed inhibit channel 1 and spindle inhibit
;of Spindle 1
[Pos11]
ChanStatFeedStop = 2 ;channel status, channel 2 is displayed,
superimposed
;from feed inhibit, channel 2
[Pos13]
SpindStat=2 ;spindle status of spindle 2
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
; "Synchronism: Synchronous spindle"
; "Synchronous spindle deactivation position"
; "Waiting for enable of the transformer axis"
; "Waiting because of possible collision"
; "JOG: Position reached %2 %3 %4"
; "JOG: Direction inhibited %2 %3 %4"
; "Brake requirement %2 %3 %4"
; "Wait: G4 S%1 still: %2 U"
: "Axial feed inhibit from PLC %2 %3 %4"
; "Waiting for axial feed enable"
: "Axial feed inhibit from Synact %2 %3 %4"
; "Waiting for master spindle speed %1"
; "Waiting for parameter change %2 %3 %4"
; "Waiting for end of motion %2 %3 %4 before transformation
change"
List of the INI Files
A.9 HEADER.INI
285