Siemens SINUMERIK Commissioning Manual page 540

Appendix
A.3 List of accessible system variables
Name
$MN_MAX_SUMCORR_
PERCUTTING_EDGE
$MN_MM_KIND_OF_SUMCORR
$MN_MM_NUM_CC_MAGAZINE_
PARAM
$MN_MM_NUM_CC_MAGLOC_
PARAM
$MN_MM_NUM_CC_MON_ PARAM
$MN_MM_NUM_GLOBAL_BASE_
FRAMES
$MN_MM_NUM_SUMCORR
$MN_MM_NUM_TOOL_ADAPTER
$MN_MM_TOOL_MANAGEMENT_
MASK
$P_UBFR[ x ,MI]
$P_UBFR[x,RT]
$P_UBFR[x,SC]
$P_UBFR[x,SI]
$P_UBFR[x,TR]
$P_CHBFRMASK
$P_EG_BC[a]
$P_NCBFRMASK
$P_OFFN
$P_PFRAME[x,TR]
$P_ACTFRAME
$P_IFRAME
$P_TOOL
$P_TOOLL[1]
$P_TOOLL[2]
$P_TOOLL[3]
$P_TOOLND[x]
$P_TOOLNO
$P_TOOLR
$P_UIFR[x,y,MI]
$P_UIFR[x,y,RT]
$P_UIFR[x,y,SC]
$P_UIFR[x,y,SI]
$P_UIFR[x,y,TR]
$P_UIFRNUM
$R[x]
$SC_PA_ACTIV_IMMED[x]
$SC_PA_CENT_ABS[x,0]
A-12
Index
x=FrameNo
x=FrameNo
x=FrameNo
x=FrameNo
x=FrameNo
or
or
x=ToolNo
x=FrameNo, y=Axis
x=FrameNo, y=Axis
x=FrameNo, y=Axis
x=FrameNo, y=Axis
x=FrameNo, y=Axis
x=ParameterNo
x=Number protection zone
x=Number protection zone
Description
Max. number of total offsets per cutting edge
Properties of total offsets in NCK
Number of parameters for one tool magazine
Number of parameters for one tool magazine
location
Number of parameters of monitoring user data
of one tool edge
Number of channel-dependent basic frames
Total number of total offsets in NCK
Max. number of traversed tool adapter data
blocks
Settings NCK tool management
Mirroring of settable frame
Rotation of settable frame
Scaling factor of settable frame
Fine offset for frames
Translation of settable frame
Active channel-specific basic frames
EG block change criterion
Active channel-independent basic frames
Offset normal
Compilation of active frame
Number of active tool edge
Active tool length 1
Active tool length 2
Active tool length 3
Number of cutting edges
Number of active tool
Active tool radius
Mirroring of settable frame
Rotation of settable frame
Scaling factor of settable frame
Fine offset for frames
Translation of settable frame
Index of active set frame
R parameters
Immediately active after referencing
Abscissa of arc center of 1st contour element
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
Expanding the user interface