Siemens SINUMERIK Commissioning Manual page 263

4. Switchover by changing the machine data 10240.
5. Switchover by changing the machine data 10240.
See also
Description of the code carrier data (Page 258)
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
$MN_SCALING_SYSTEM_IS_METRIC.
Then call tool management and Power ON reset in the already selected tool
management. This corresponds to point 3.
$MN_SCALING_SYSTEM_IS_METRIC.
Then call tool management and machine control panel reset in the already selected tool
management.
– Tool detail displays and list displays: As the individual values are immediately written
after input and are constantly updated in these displays, the data is immediately
displayed in the new unit.
– Catalog/cabinet displays with affected data: As the entered data is only written in full
to the database when a softkey with a "Save function" (e.g. <OK>, <New cutting
edge>) is activated, the new unit only becomes active after this type of action.
Tool management
6.6 Inch/metric setting
257