Siemens SINUMERIK Commissioning Manual page 188

Tool management
6.1 Setting tool management parameters on the HMI
6.1.7 Magazine configuration
Create magazine configuration
For each TO unit, there is only one common magazine configuration for configuring the tool
management. A magazine configuration can consist of one or more real magazines. As one
TO unit can be assigned to several channels, this magazine configuration is available to the
associated channels simultaneously.
In this screen, new data required for the selected magazine is defined or existing data is
displayed.
Figure 6-11
Configurations
Name
Tool search
182
Magazine configuration
Name of the magazine configuration (max. 32 characters).
transfer from configuration (Default setting: Setting for
$TC_MAP10=0, NCK uses values from $TC_MAMP2).
active tool/min. duplo
Shortest path
active tool/min. $TC_TP10
Monitoring: min. actual value
Monitoring: max. actual value
Settings for the location coding can be variable (default) or fixed.
Exit the screen by pressing the "Cancel" or "OK" softkey.
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)