Siemens SINUMERIK Commissioning Manual page 207

; TOWSTD = G56-current-value
G56ResetTOWSTDEqualCurrBitmap = pestd.bmp
; File name of bitmap used in lists to show: G56-reset-value =
; TOWMCS <> G56-current-value
G56ResetTOWMCSUnequalCurrBitmap = pumcs.bmp
; File name of bitmap used in lists to show: G56-reset-value =
; TOWMCS <> G56-current-value
G56ResetTOWWCSUnequalCurrBitmap = puwcs.bmp
; File name of bitmap used in lists to show: G56-reset-value =
; TOWSTD <> G56-current-value
G56ResetTOWSTDUnequalCurrBitmap = pustd.bmp
; In order to prevent excessive horizontal scrolling, cursor moves
; automatically to leftmost column in lists during the following
; actions: Magazine lists: softkey "Load" and softkeys "Start"
; and "Abort" in tool loading mode
; tool lists: softkey "New tool".
; CursorMovesLeftmostBySomeActions=True ;default
;CursorMovesLeftmostBySomeActions=False
; In magazine list forms change softkey "Next Mag" to softkey
; "Magazine Selection", to activate vertical softkeys in an
; additional state for magazine selection.
; This helps to prevent users from excessive use of "next mag"
; softkey if a lot of magazines are available.
; You can define shortcut softkeys for up to 5 favorite magazines
; per TOA using section [ShortcutSoftKeysForMagSelect] in
; paramtm.ini and patm_??.ini.
; MagListMagSelectSoftkey=NextMag ; default
;MagListMagSelectSoftkey=SelectMag
; Magazine list: Display buffer initially
DisplayBufferInMagList = InitialVisible
; default behaviour as of version 6.4.1.
; Whenever an other magazine is visited in magazine list:
; automatically show its buffer too.
; The buffer is hidden temporarily after the user has pressed
; the softkey "buffer".
;DisplayBufferInMagList = InitialNotVisible
; old behaviour before version 6.4.1.
; In magazine list: At the beginning no buffer is shown.
; After a magazine which doesn't have a buffer was visited,
; no buffer is then always shown for other magazines either.
; The buffer is shown temporarily after the user has pressed
; the softkey "buffer".
[SoftKeysForMagAndToolList]
; Text for the softkeys for magazine lists and tool lists.
; The locale mechanism is used.
; For details of this mechanism, see the section on
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Tool management
6.2 Settings in the configuration file
201