Siemens SINUMERIK Commissioning Manual page 203

; 0: Do not read
ReadLanguageIni=1
SearchPlaceMethod=NoInternalTool ; Don't modify!
; Tool details forms: colors for mixed adapter transformed/
; untransformed display:
; Hex values, 8 characters per color(SSBBGGRR where SS=System,
; BB=Blue, GG=Green, RR=Red)
; 4 Values for:
TransformedText, TransformedBackground,
NotTransformedText, NotTransformedBackground
DetailsMixedTrafoColors=WinTxt, li-brown,WinTxt ,li-blue
DetailsMixedTrafoColors =80000008,00008080,80000008,00FFFF00
; Allow display and edit of all 3 len parameters L1 L2 L3 in
; cut edge geo, cut edge wear, SC, EC independent of tool type and
; independent of $SC_TOOL_LENGTH_CONST and $SC_TOOL_LENGTH_TYPE
; in tool management lists, detail forms, cabin and catalogue.
AllwaysAllowL1L2L3IO=False ;default
; AllwaysAllowL1L2L3IO=True
; Allow change of Tool state bit 8 (least significant bit is Bit 1)
; (TC_TP8_8 "ToolState Used, Tool was being used") via GUI (list
; and details forms) for NCU tools.
; default: FALSE
AllowChangeOfTC_TP8_8 = False ;default
; AllowChangeOfTC_TP8_8 = True
[GeneralSettingsForMagAndToolList]
ToolState_Lang_12345678=<Empty> ; use language-DLL
; If MagPlaceState_Lang_12345678 and ToolState_Lang_12345678
; are not defined here or equal "<Empty>", then the
; locale-dependent values in the magazine and tool list from
pa_xx.dll are
; displayed.
; If values are set here and the entry in the "[General]" section
for
; "ReadLanguageIni" equals 1, then the files
; mmc2\language\patm_gr.ini, user\language\patm_gr.ini etc. are
searched
; in the same section as here. The name for the entry that is used
; in the locale-dependent file is the value of the entry
; from paramtm.ini.
; If an entry is found in the locale-dependent file,
; then it is used as text.
; If it is not found or if "...=<Empty>" is found,
; then the value from the paramtm.ini file is used as text.
; The 8 characters in MagPlaceState_Lang_12345678 and
; ToolState_Lang_12345678 correspond to the 8 magazine location
; and tool states and are displayed as location or tool status
values
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Tool management
6.2 Settings in the configuration file
197