Siemens SINUMERIK Commissioning Manual page 483

Configure hotkeys and PLC keys
4.1 Introduction
4.1
Overview
This chapter describes the configuration of the following control elements:
● 6 hotkeys on OP 010, OP 010C and SINUMERIK keyboards with hotkey block, as well as
● Keys evaluated by the PLC, e.g., keys on the machine control panel
● Events that are evaluated by the PLC as PLC keys or "virtual keys", and that can trigger
PLC
Figure 4-1 Configuration with OP 010
Application
The hotkeys and keys can be used for, e.g., the following tasks:
● Selection of operating areas (e.g., Machine, Parameters, etc.)
● Selection of specific submenus (e.g., selection of the alarm screen in the Diagnosis
● Initiation of actions (e.g., selection of the tool list in the Parameters area and pressing of
● Specific selection of menus created using the "Expanding the Operator Interface" system
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
the <MACHINE> and <MENU SELECT> keys, whose assignment can be changed.
configured operating sequences in the HMI program.
Interface
MCP
operating area)
softkey HS3)
PCU
Hard disk (HMI Advanced only)
e.g., OP 010 (schematic)
4
4-1