Siemens SINUMERIK Commissioning Manual page 61

Switching over channels
The following channel menu is displayed when the channel switchover key is pressed with
this configuration.
Select the channel menu using the channel switchover key from any operating area of the
HMI, as shown in the following example:
Figure 2-6
Triggering channel switchover:
● Select the channel group (station) with the horizontal softkeys.
● The channels belonging to this group are now displayed on the vertical softkeys.
See also
NETNAMES.INI (Page 308)
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Example channel menu
The control does not switch to the channel until the vertical softkey is pressed.
Configuring the HMI system
2.2 Configuring a channel menu
55