Siemens SINUMERIK Commissioning Manual page 190

Tool management
6.1 Setting tool management parameters on the HMI
6.1.8 How to create and load a configuration
Create new magazine configuration
The "Configuration" and "Real magazine" screens show the location type assignments for
the entire configuration or the selected magazine.
1. Press the "New" softkey.
2. Enter a name, e.g. Example_documentation (32 characters max.)
3. Select selection menu for the tool search, location search and wear group and make the
4. Press the "OK" softkey (create the magazine configuration).
Note
The "Assign" and "Deassign" softkeys always refer to the selection field the cursor is
positioned on:
• Magazine
• Location type
Process
Assign/deassign real magazines:
1. Select a real magazine and press the "Assign" softkey. This real magazine is then
2. After each assignment, the total number of magazine locations is accordingly updated in
3. You can remove a magazine again from the magazine configuration by pressing the
Assign/deassign location types
1. Select location type. Enter magazine locations to which this location type is to be
2. Example: "From location: "1", "To location: "10".
3. Press the "Assign" softkey. The defined locations are displayed with the color for this
4. You can remove the assignment made for a location type by pressing the "Deassign"
Create configuration file:
● Press the "Create config. file" softkey. An INI file is created which can later be uploaded
Copy configuration
1. Press the "Copy" softkey.
2. Enter a new name and confirm by pressing the "OK" softkey.
184
settings as appropriate.
included in the magazine configuration.
the configuration.
"Deassign" softkey.
assigned.
location type
softkey.
to the NCK.
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
HMI Advanced (IM4)