Siemens SINUMERIK Commissioning Manual page 417

Programming
Syntax:
Description:
Parameters:
Block numbers and skip identifiers
The OUTPUT block must not contain line numbers or skip identifiers if you wish to keep the
line numbers and hide markings directly set with active program support in the parts program
in case of recompilations.
Editor changes in the parts program produce the following response:
Condition
Number of blocks remains unchanged.
Number of blocks is reduced.
Number of blocks is increased.
Example
OUTPUT(CODE1)
"CYCLE82(" Var1.val "," Var2.val "," Var3.val ","Var4.val "," Var5.val
"," Var6.val ")"
END_OUTPUT
2.6.7 PRESS
Description
The PRESS method is executed when the corresponding softkey is pressed.
Programming
Syntax:
Identifiers:
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
(Identifier)
OUTPUT
...
END_OUTPUT
Outputs variables in the NC program.
Identifier
Response
Block numbers are retained.
The highest block numbers are canceled.
New blocks are not numbered.
(softkey)
PRESS
...
END_PRESS
Pressing a softkey
Name of OUTPUT method
Programming
2.6 Methods
2-67